Cisco Small Business 200, Руководство администратора

Страница: 347 / 351

SNMP
Notification Recipients
Cisco Small Business 200 Series Smart Switch Administration Guide 334
21
It is also possible to filter certain notifications. This can be done by creating a filter
in the Notification Filter page and attaching it to an SNMP notification recipient.
The notification filter enables filtering the type of SNMP notifications that are sent
to the management station based on the OID of the notification that is about to be
sent.
Defining SNMPv1,2 Notification Recipients
To define a recipient in SNMPv1,2:
STEP 1
Click SNMP > Notification Recipients SNMPv1,2 .
This page contains recipients for SNMPv1,2.
STEP 2
Click Add.
STEP 3
Enter the parameters.
• Server Definition —Select whether to specify the remote log server by IP
address or name.
• IP Version —Select either IPv4 or IPv6.
• IPv6 Address Type —Select either Link Local or Global .
- Link Local —The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80 , is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global —The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface —If the IPv6 address type is Link Local, select whether
it is received through a VLAN or ISATAP.
• Recipient IP Address/Name —Enter the IP address or server name of
where the traps are sent.
• UDP Port —Enter the UDP port used for notifications on the recipient device.
• Notification Type —Select whether to send Traps or Informs. If both are
required, two recipients must be created.
• Timeout—Enter the number of seconds the device waits before re-sending
informs.