Cisco Small Business 200, Руководство администратора

Страница: 131 / 351

Port Management
Configuring Link Aggregation
Cisco Small Business 200 Series Smart Switch Administration Guide 118
9
Static and Dynamic LAG Workflow
After a LAG has been manually created, LACP cannot be added or removed until
the LAG is edited and a member is removed. Only then the LACP button become
available for editing.
To configure a static LAG, perform the following actions:
1. Disable LACP on the LAG to make it static. Assign up to eight member ports to
the static LAG by selecting and moving the ports from the Port List to the LAG
Members list. Select the load balancing algorithm for the LAG. Perform these
actions in the LAG Management page.
2. Configure various aspects of the LAG, such as speed and flow control by using
the LAG Settings page.
To configure a dynamic LAG, perform the following actions:
1. Enable LACP on the LAG. Assign up to 16 candidates ports to the dynamic LAG
by selecting and moving the ports from the Port List to the LAG Members List
by using the LAG Management page.
2. Configure various aspects of the LAG, such as speed and flow control by using
the LAG Settings page.
3. Set the LACP priority and timeout of the ports in the LAG by using the LACP
page.
Defining LAG Management
The LAG Management page displays the global and per LAG settings. The page
also enables you to configure the global setting and to select and edit the desired
LAG on the Edit LAG Membership page.
To select the load balancing algorithm of the LAG:
STEP 1
Click Port Management > Link Aggregation > LAG Management.
STEP 2
Select one of the following Load Balance Algorithms :
• MAC Address —Perform load balancing by source and destination MAC
addresses on all packets.
• IP/MAC Address —Perform load balancing by the source and destination IP
addresses on IP packets, and by the source and destination MAC addresses
on non-IP packets