Administration: System Logs
Configuring Remote Logging Settings
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x
39
3
Configuring Remote Logging Settings
Use the Remote Log Servers page to define the remote SYSLOG servers where
log messages are sent (using the SYSLOG protocol). For each server, you can
configure the severity of the messages that it receives.
To configure a remote SYSLOG server:
STEP 1
Click
Administration
>
System Log
>
Remote Log Servers
.
STEP 2
Click
Add
to add a remote SYSLOG server.
STEP 3
Enter the following information:
•
Server Definition
—Select whether to identify the remote log server by IP
address or name.
•
IP Version
—Select either
Version 4
or
Version 6
if the remote log server is
identified by IP address.
•
Log Server IP Address/Name
—Enter the IP address or hostname of the
remote log server.
•
UDP Port
—Enter the UDP port to which the log messages are sent.
•
Facility
—Select a facility from which system logs are sent to the remote
server. Only one facility can be assigned to a server.
•
Minimum Severity
—Select the minimum level of system log messages to
be sent to the server.
STEP 4
Click
Apply
. The remote SYSLOG server is added, and the Running Configuration
is updated.
Viewing Memory Logs
The switch can write to the following logs:
•
Log in RAM (cleared during reboot). See
for
more information.
•
Log in flash memory (cleared only upon user command). See
for more information.
