Cisco RF Gateway 1 Modules, Руководство по настройке

Страница: 55 / 286

QAM Card Configuration
78-4025112-01 Rev H0 31
Parameter Description
ITU Carrier Number This field is only seen if your annex is ITU-B and you have a standard
frequency plan selected.
Example: In North America, channel 50 is determined to have a center
frequency of 381 MHz. Selecting the first channel number picks up the
corresponding frequency for channel 1 on that port. The remaining
frequencies are populated automatically by channel spacing. Based on
those frequencies, the remaining channel numbers are populated.
Note: There are certain restrictions on the channel number.
Carrier Center
Frequency Allows you to choose the center frequency of channel 1 and the
remaining channels are populated automatically.
Note: There are certain restrictions on the channel number.
Global QAM Channel Configuration
Global QAM Channel Configuration allows you to configure QAM channels on a
global level. See the following screen.
Parameters
The following table describes the Global QAM Channel Configuration parameters.
Parameter Description
RFGW QAM Channel RFGW QAM channels are shown in the following format.
Example: 1/2.3 = card 1, port 2, channel 3.
SRM QAM Channel SRM QAM channels are shown in the following format.
Example: 1 = SRM Channel 1
ON ID Original Network Identifier (range 0-65535).
TS ID Transport Stream Identifier (range 0-65535).
Mode The channel mode can be normal, continuous, or mute. The
default setting is always mute.