Cisco ONS 15454 DWDM, Инструкция по установке и эксплуатации

Страница: 567 / 1218

10-41
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 10 Manage the Node
DLP-G186 Delete an OSC Termination
Step 2 Click the GCC that you want to delete.
Step 3
Click Delete.
Step 4
In the Delete GCC Terminations dialog box, check the Set port OOS check box if you want to place
ports out of service.
Step 5
Click Yes . GCC-EOC alarms appear until all network GCC terminations are deleted and the ports are
out of service.
Step 6 Return to your originating procedure (NTP).
DLP-G186 Delete an OSC Termination
Caution Deleting a OSC termination might cause node isolation and loss of visibility to nodes that do not have
other OSCs or network connections to the CTC computer.
Step 1
Click the Provisioning > Comm Channel > OSC tab.
Step 2
If a Ring ID is created, complete the following steps. Otherwise, continue with Step 3 .
a. Select the DWDM Ring ID that you want to delete and click Delete .
b.
In the Delete DWDM Ring ID confirmation box, click Yes . Confirm that the changes appear.
Step 3 Click the OSC termination that you want to delete and click Delete .
Step 4
In the Delete OSC Termination confirmation box, click Yes . Confirm that the changes appear.
Until all network OSC terminations are deleted, loss of signal (LOS) or power failure alarms on the
OPT-BST amplifier, OSCM card, and OSC-CSM card might appear.
Step 5
Return to your originating procedure (NTP).
Purpose This task deletes an OSC termination on the ONS 15454.
Tools/Equipment None
Prerequisite Procedures DLP-G46 Log into CTC, page 2-25
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher