NAME: "0/FT0", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
, VID: V01, SN: N/A
NAME: "0/FT1", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
, VID: V01, SN: N/A
NAME: "0/FT2", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
, VID: V01, SN: N/A
NAME: "0/PM0", DESCR: "Network Convergence System 1000 2KW AC PSU"
PID: NCS1K-2KW-AC
, VID: V01, SN: POG2041J0BW
NAME: "0/PM1", DESCR: "Network Convergence System 1000 2KW AC PSU"
PID: NCS1K-2KW-AC
, VID: V01, SN: POG2041J01C
You can verify if any QSFP or CFP has been removed from the NCS 1002.
Verify Node Status
You can verify the operational status of all the nodes using the
show platform
command. You can execute
this command independently from both the Cisco IOS XR EXEC and System Admin EXEC modes.
To verify the operational status of all the nodes, perform the following procedure.
Procedure
Step 1
show platform
When you execute this command from the XR EXEC mode, the status of the Cisco IOS XR is displayed.
Verify that the node state is Operational and admin state is UP.
Example:
RP/0/RP0/CPU0:ios#
show platform
Wed Feb 28 03:28:40.004 UTC
Node
Type
State
Config state
--------------------------------------------------------------------------------
0/RP0/CPU0
NCS1K-CNTLR(Active)
IOS XR RUN
NSHUT
If the Cisco IOS XR is not operational, no output is shown in the result. In this case, verify the state of SDR
on the node using the
show sdr
command in the System Admin EXEC mode.
Step 2
admin
Enters System Admin EXEC mode.
Example:
RP/0/RP0/CPU0:ios#
admin
Step 3
show platform
Displays information and status for each node in the system.
Example:
System Setup and Software Installation Guide for Cisco NCS 1002
21
Perform Preliminary Checks
Verify Node Status
