Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-02
5-3
Step 4
Press
Enter
several times until the Cisco logo appears on the local terminal and the setup
configuration dialog is entered.
--- System Configuration Dialog ---
At any point you may enter a question mark ‘?’ followed by ‘Enter’ for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets ‘[]’.
Would you like to continue with the System Configuration Dialog? [yes/no]:
y
Step 5
Type y and press
Enter
.
The system configuration dialog begins.
Initial System Configuration
Upon initial connection to the local terminal, as described above, the system configuration wizard
automatically runs to guide the user through the entire setup process. The wizard prompts for all
necessary parameters, displaying default values, where applicable. You may accept the default
values or define other values.
With the exception of the time settings, which take effect immediately when entered, the new
configuration is applied and saved only at the end of the dialog when approved by the user.
Therefore, if the setup dialog is aborted, no change takes place in the configuration, other than
time settings (if entered).
When the dialog is complete, you may review the new configuration before applying it. The
system displays the configuration, including parameters that were not changed. The system also
displays any errors that are detected in the configuration. When the configuration is satisfactory,
you may apply and save the new configuration.
The following table lists all the parameters included in the initial configuration. It is
recommended that you obtain values for any parameters that you will configure at this time before
beginning the setup.
Note
For further information regarding any configuration step or specific parameter, refer to the relevant
section in the
Cisco Service Control Engine (SCE) Software Configuration Guid
e.
Table 5-1
Setup Command Parameters
Parameter Definition
IP address
IP address of the
SCE 2000
.
subnet mask
Subnet mask of the
SCE 2000
.
default gateway
Default gateway.
hostname
Character string used to identify the
SCE 2000
