Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Initial System Configuration
SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-02
5-5
SNMP agent status
Enable or disable SNMP management.
GET community names
Community strings to allow GET access and associated ACLs (maximum
20).
SET community names
Community strings to allow SET access and associated ACLs (maximum
20).
trap managers (maximum
20)
Trap manager IP address, community string, and SNMP version.
Authentication Failure
trap status
Sets the status of the Authentication Failure traps.
enterprise traps status
Sets the status of the enterprise traps.
system administrator
Name of the system administrator.
Topology Configuration
connection mode
Is the
SCE 2000
installed in bump-in-the-wire topology (inline) or out of
line using an optical splitter (receive-only)?
type of deployment
Is this a cascade topology, with two
SCE 2000
s connected via the cascade
ports? Or is this a single platform topology?
physically connected link
(cascade topology only)
In a cascade deployment this parameter sets the index for the link that this
SCE 2000
is deployed on. The options for
SCE 2000
are link-0 or link-1.
In a single-
SCE 2000
Platform deployment this parameter is not relevant
since one
SCE 2000
is deployed on both links. In this case the link
connected to port1-port2 is by default link-0 and the link connected to
port3-port4 is by default link-1.
priority
(cascade topology only)
If this is a cascaded topology, is this
SCE 2000
the primary or secondary
SCE 2000
?
on-failure behavior
(inline connection mode
only)
If this
SCE 2000
is deployed inline, should the failure behavior be bypass
or cutoff of the link?
Admin status of the
SCE
2000
after abnormal boot
After a reboot due to a failure, should the
SCE 2000
remain in a Failure
status or move to operational status provided no other problem was
detected?
Following are some general instructions regarding the setup dialog:
•
All default values appear in square brackets [
default
].
If no value appears in the brackets [], or more than one option appears [
yes/no
], then this
parameter does not have a default value.
•
To accept the default value, press
Enter.
•
If you need more information about any parameter, type
?
and press
Enter
.
A help message will appear describing the expected format of the parameter and any other
requirements.
•
To jump to the
end of the setup dialog at any point, accepting all remaining default values,
press
^z.
