Cisco Catalyst 4500e Series, Руководство по установке

Страница: 96 / 152

4-22
Catalyst 4500 E-Series Switches Installation Guide
OL-13972-01
Chapter 4 Removing and Replacing FRUs
Supervisor Memory Upgrade
Step 3
Hold the miniDIMM component-side up, with connector edge (the metal fingers) away from you. Keep
the sides of the miniDIMM between your thumb and middle finger, with your forefinger against the far
edge and opposite the connector edge. (See
Figure 4-27 .)
Figure 4-27 Handling a miniDIMM
Step 4
Tilt the miniDIMM to the same angle as the socket, then insert the connector edge into the socket. Gently
push into place until the metal clips snap into place.
Caution
It is normal to feel some resistance when installing a miniDIMM, but do not use excessive force and do
not touch the surface components.
Step 5
Check the two alignment holds and ensure that the metal clips are visible. If necessary, carefully remove
and reseat the miniDIMM.
Step 6
If you are upgrading memory from 512 Mb to 1 Gb and you have removed the miniDIMM in u39, replace
it as in steps 3-5.
Step 7
Replace the supervisor engine in the switch.
33115