Cisco Catalyst 2360, Руководство по настройке программного обеспечения

Страница: 457 / 554

28-13
Catalyst 2360 Switch Software Configuration Guide
OL-19808-01
Chapter 28 Troubleshooting
Using Ping
Using Ping
These sections contain this information:
•
Understanding Ping, page 28-13
• Executing Ping, page 28-13
Understanding Ping
The switch supports IP ping, which you can use to test connectivity to remote hosts. Ping sends an echo
request packet to an address and waits for a reply. Ping returns one of these responses:
• Normal response—The normal response ( hostname is alive) occurs in 1 to 10 seconds, depending
on network traffic.
•
Destination does not respond—If the host does not respond, a no-answer message is returned.
• Unknown host—If the host does not exist, an unknown host message is returned.
•
Destination unreachable—If the default gateway cannot reach the specified network, a
destination-unreachable message is returned.
• Network or host unreachable—If there is no entry in the route table for the host or network, a
network or host unreachable message is returned.
Executing Ping
Beginning in privileged EXEC mode, use this command to ping another device on the network from the
switch:
Note
Though other protocol keywords are available with the ping command, they are not supported in this
release.
This example shows how to ping an IP host:
Switch# ping 172.20.52.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echoes to 172.20.52.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/2/4 ms
Switch#
Command Purpose
ping ip host | address Ping a remote host through IP or by supplying the hostname or
network address.