Cisco Catalyst 2360, Руководство по настройке программного обеспечения

Страница: 451 / 554

28-7
Catalyst 2360 Switch Software Configuration Guide
OL-19808-01
Chapter 28 Troubleshooting
Recovering from a Lost or Forgotten Password
The switch file system appears:
Directory of usbflash0:
2 -rw- 8736183 <date> c2360-universal-mz
1022853120 bytes available (21938176 bytes used)
57671680 bytes total (35600896 bytes free)
Step 4 Boot up the system:
Switch: boot
You are prompted to start the setup program. To continue with password recovery, enter N at the prompt:
Continue with the configuration dialog? [yes/no]: N
Step 5 At the switch prompt, enter privileged EXEC mode:
Switch> enable
Step 6
Enter global configuration mode:
Switch# configure terminal
Step 7 Change the password:
Switch (config)# enable secret password
The secret password can be from 1 to 25 alphanumeric characters, can start with a number, is case
sensitive, and allows spaces but ignores leading spaces.
Step 8 Return to privileged EXEC mode:
Switch (config)# exit
Switch#
Step 9
Write the running configuration to the startup configuration file:
Switch# copy running-config startup-config
The new password is now in the startup configuration.
Note This procedure is likely to leave your switch virtual interface in a shutdown state. You can see
which interface is in this state by entering the
show running-config privileged EXEC command.
To re-enable the interface, enter the interface vlan vlan-id global configuration command, and
specify the VLAN ID of the shutdown interface. With the switch in interface configuration
mode, enter the
no shutdown command.
Step 10 You must now reconfigure the switch. If the system administrator has the backup switch and VLAN
configuration files available, you should use those.