3-3
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
OL-15790-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Understanding the Cisco Unified IP Phone 7975G Components
•
Access port—Labeled 10/100/1000 PC on the Cisco Unified IP Phone 7975G
You can use either Category 3 or 5 cabling for 10-Mbps connections, but you must use Category 5 for
100 and 1000 Mbps connections.
Use the SW network port to connect the phone to the network. You must use a straight-through cable on
this port. The phone can also obtain inline power from a switch over this connection. See the
“Providing
Power to the Phone” section on page 2-3
for details.
Use the PC access port to connect a network device, such as a computer, to the phone. You must use a
straight-through cable on this port.
Handset
The wideband-capable handset is designed especially for use with a Cisco Unified IP Phone. It includes
a light strip that indicates incoming calls and voice messages waiting.
To connect a handset to the Cisco Unified IP Phone, plug the cable into the handset and into the Handset
port on the back of the phone.
Speakerphone
By default, the wideband-capable speakerphone is enabled on Cisco Unified IP Phone 7975G.
You can disable the speakerphone by using Cisco Unified Communications Manager Administration. To
do so, choose
Device > Phone
and locate the phone you want to modify. In the Phone Configuration
window for the phone, check the
Disable Speakerphone
check box.
Headset
Although Cisco Systems performs internal testing of third-party headsets for use with the Cisco Unified
IP Phones, Cisco does not certify or support products from headset or handset vendors.
Cisco recommends the use of good quality external devices, for example, headsets that are screened
against unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of
headsets and their proximity to other devices such as mobile phones and two-way radios, some audio
noise or echo may still occur. An audible hum or buzz may be heard by either the remote party or by both
the remote party and the Cisco Unified IP Phone user. Humming or buzzing sounds can be caused by a
range of outside sources; for example, electric lights, electric motors, or large PC monitors. See
Using
External Devices, page 3-5
, for more information.
Note
The Cisco Unified IP Phone 7975G supports wideband headsets.
Note
In some cases, hum may be reduced or eliminated by using a local power cube or power injector.
These environmental and hardware inconsistencies in the locations where Cisco Unified IP Phones are
deployed means that there is not a single headset solution that is optimal for all environments.
Cisco recommends that customers test headsets in their intended environment to determine performance
before making a purchasing decision and deploying en mass.
