VCC-5CL1M
Rev.
905-0003-02
©2015 CIS Corporation. All rights reserved.
7
※
This camera performs an automatic calibration at the start-up or the time of the following function
settings.
An input of the luminosity which exceeds a saturation level at the time of this automatic calibration may reduce
the white clip level and the setup level. In such a case, hold down an input image to the luminosity
(recommendation is a shading state) which is not saturated, then re-setup or reboot. The camera returns to a
normal state. In addition, this automatic calibration cannot be disabled.
＜
Functions to perform the automatic calibration
＞
Camera mode setting
（
Address 1
）
, Horizontal partial setting (Address 55)
Binning mode setting (Address 56), HDR mode setting (Address 90)
※
Up to 6 seconds shall be required after turning on power to get proper camera operation.
4.3.
Input/output Circuitry of 12pin circular connector
◇
12pins connector Pin No 11: Trigger input
・
5.0V
、
3.3V
CMOSL level input
（
TTL compatible
）
・
Input voltage
Low: 0.5Vdc(Min), Hi: 2.1Vdc(Max)
HD74LV1GT14A (Renesas)
1
2
3
5
4
100
1K
+5.0V
◇
12pins connector Pin No 9: Exposure output
・
5.0V CMOS logic level output
・
Output voltage
Low: 0.55Vdc Max, Hi: 3.8Vdc
Min
+5.0V
HD74LV1GT32ACME (Renesas)
1
2
3
4
5
100
◇
12pins connector Pin No 6, Pin No 10: Isolated trigger input with photo coupler
・
Input voltage
Low: 0-1Vdc, Hi: 3-24Vdc (Max. 24V)
※
Do not input the voltage range of 1 to 3Vdc which shall cause the operation unstable.
・
Regardless of input voltage, on Hi level the photo coupler is driven with 4 mA by inner constant current
circuit.
・
The delay time of the photo coupler for t_on is approx. 5
µ
s and t_off is approx. 35
µ
s.
11 pin
9 pin
