Introduction and Setup Page 5
Note:
After you accept the terms of agreement, install a driver and the software for the USB to
UART device as prompted.
Step 6
A read-me file will automatically open. You can
read the file if desired. When you are ready to
continue, close the window and complete the
installation.
Step 7
If you are setting up a CR tester,
remove the thumb drive
and proceed to “Setting up a CR
Tester” on the next page.
If you are setting up a CH2 tester,
leave thumb drive in
and proceed to “Setting up a CH2
Tester” on page 8.
