Introduction and Setup Page 9
Step 6
On the front of the CH2 tester, plug in the
probe.
Step 7
Plug the HV Interface Connector labeled
“Connector 1” into the first scanner position
on the CH2 tester. Then snap the top and
bottom levers on the Cirris Connector Saver
into place.
Step 8
Plug the HV Interface Connector labeled
“Connector 2” into the second scanner
position on the CH2 and snap the top and
bottom levers into place as shown.
Note:
This demo comes with a Cirris CH2 Connector Saver (Cirris P/N: ADCS-C2) installed
which allows you to quickly attach cables to the tester. Connector Savers also protect pins in the
CH2 from wear and damage. CH2 connector savers are sold separately from the CH2 tester.
Step 9
Plug the other end of the HV Interface Cable
into the HV Transition Board connector on
the harness board.
Note:
The HV Transition Board Connector allows you to quickly plug in an interface connector
for the device-under-test.
Step 10
The drop nail bracket is located at the center
of the demo harness board. Pinch and raise
the drop nail bracket to raise the drop nails
as shown.
Probe
HV Interface
Connectors 1 and 2
HV Interface
Cable
Transition Board
Connector
Drop Nails
Cirris Connector Saver
Top Levers
Bottom Levers
Drop Nail
Bracket
