Circutor SVGm, Инструкция по эксплуатации

Страница: 44 / 108

44
SVGm
Instruction Manual
5.- START-UP
When the device has been powered on, one of the screens in
Figure 38
appears on the display.
Screen of a “Single” device or “Master” Screen of a “Slave” device
Figure 38: Home screen�
Before starting the static generator, it is necessary to follow the steps below:
1�- Use the key to navigate to the configuration screen and implement the appropriate configu-
ration according to the existing installation ( see
“ 7.- CONFIGURATION”
).
2�- (Device “single” or “master” ) Use the key to navigate to the voltage and current display screen
(
“6.2.- VOLTAGE, CURRENT AND FREQUENCY”
), and:

Make sure the voltage measurements correspond to the real voltages of the installation.

Make sure the load current measurements correspond to the current levels of the installa-
tion.
3�- (Device “single” or “master” ) Use the key to navigate to the display screen of the load pa-
rameters (
“6.4.- POWER AND COS ɸ OF LOAD”
) and:

Make sure the
active power
measurement of the load corresponds to the active power levels
of the installation.

Make sure the
reactive power
measurement of the load corresponds to the reactive power
levels of the installation.

Check the cos
ɸ
in the three phases. If phases appear with very high reactive power and very
low active power levels, this may indicate an error in the phase order. In this case, check the
power supply and current input connections.
4�-
(Device
“single”
or
“master”
) Go back to the home screen of the device,
Figure 38
, if there is no
problem with the connections, the upper area should show the message “ Stop” .
If there is a problem with the static generator connections or the configuration, the
“Waiting for con-
ditions”
message appears.
5�-
(Device
“single”
or
“master”
) Press the key to start the static generator. If it has started
correctly, the screen will show the message “ Run ”.