Circutor DHC-96 Adc, Инструкция по эксплуатации

Страница: 25 / 50

Use the and keys to browse the configuration screens of the menu.
5�3�3�- READING FOR THE END OF THE ANALOG OUTPUT
In this screen, the reading value from which the analog output ends is configured.
FS 5.000
Use the , key to modify the value of the flashing digit
When the desired value is shown on the screen, press the key to skip the digit.

Configuration values
Table 18:Configuration values: Reading for the end of the analog output�
Reading for the end of the analog output
Minimum value 0.5 x A
Maximum value 1.2 x A
Note:
In the
DHC-96 mAdc
model the variable
A
has a value of 2000, in the
DHC-96 Adc
model has a
value of 5000 for the measurement range of
5.000
and 1000 for the measurement range of
1.000
.
Note: FS (End of the analog output) - DS (Start of the analog output) ≥ 500
To validate the data, press the key.
Use the and keys to browse the configuration screens of the menu.
5�3�4�- SAVE CONFIGURATION
To save the configuration of the device, press the key, until the main screen of the input config-
uration menu is opened,
Figure 10
.
Press the key again to show the validation screen.
SAuE
no
Use the ,key to browse the different options.

Configuration values
Table 19: Configuration values: Save configuration�
Save configuration
Possible values
no
Exit the configuration without saving the changed values.
yEs
Save the changed configuration values.
25
Instruction Manual
DHC-96 mAdc, DHC-96 Adc