Cima BLITZ 45, Инструкция по эксплуатации и обслуживанию

Страница: 63 / 108

4-2012
Blitz 45 - 50 - 55
55
10a2. Close the main filler (BP) of the tank.
10a3. Complete the filling with water through the secondary filler (BS),
by keeping PTO in running.
10a4. Close the cover of the secondary filler (BS).
10b.
WITH POWDER PRODUCTS, WHEN USING THE MIXER (IF FORESEEN)
10b1. Pour the powder medicine dose into the cup-like filter of the main filler (BP).
10b2. Close the main filler (BP) of the tank.
10b3. Open the cock (P12), by positioning the lever on “
a
” (or position “1” for E.P.A. versions)
.
10b4. Complete the filling with water through the secondary filler (BS), by keeping PTO in running.
10b5. Close the cock (P12), by positioning the lever on “
c
” (or position “2” for E.P.A. versions)
.
11. Move to the place to be treated, by keeping the mixture agitation at a 500 r.p.m. PTO turning rate
along the whole way.
FILLING DIRECTLY IN THE TREATMENT AREA:
12. Disengage the power take off (PTO)
13.
Stop the tractor and remove the key from the control panel.
14. Make sure that the fan is still. Engage the impeller to the multiplier, as indicated at paragraph 8.1.b.
Tighten the protection-securing nuts properly.
15. Start the tractor.
16. Engage the Power Takeoff and set it up to a running rate of at least 500 r.p.m.
,
in order to carry
out a further agitation.
540
Use ONLY the PTO at 540 rpm. Engage the PTO with the engine of the tractor
at low speed and with maximum modularity, obtaining soft and progressive
graft and avoiding abrupt starts of the cardan shaft
17. Regulate the operating pressure, by acting on the pressure regulator (P5) (or electric E5, for
versions where provided) with the distributor, hand (P9) or electric (E9), open (DISTRIBUTION).
18. CARRY OUT THE TREATMENT (See the paragraph 11.3).
8.3 - FILLING WITH THE SPECIFIC PIPE
(optional on demand)
Before utilisation, check the operation and proper sealing of the bottom-drawing
valve by pouring water in the piping.
THE PUMP MUST NEVER RUN DRY.
EXECUTION:
1. Disengage the fan, see point 8.1.a.
2. For the versions on which it is foreseen: check that the cock (P18) is open: (lever positioned on “
1
”)
.
3. For the version where foreseen: verify that the spray-line rinsing cock (P15) is on
“1”
position.
4. Verify that the outlet on the faucet (P2) is closed by the special plug with chain.
5. Position the lever of the 3-way cock (P2) to “
B
”.
6. Close the cocks of the 2-way distributor:
a. if electric (E9), position to “
OFF
” the quick-break switches on the electrical control panel (E10)
or on the E.P.A. control unit.
b. if manual (P9), the levers are to be lowered (horizontally positioned);