Cima BLITZ 45, Инструкция по эксплуатации и обслуживанию

Страница: 37 / 108

4-2012
Blitz 45 - 50 - 55
29
P11. CALIBRATION DISC
(Patent N° 23238)
It selects the flow rates necessary to the treatment and is mounted on the distribution devices. It is
made up of 2 flanges, held in position by two butterfly nuts, locking a disc with calibrated holes numbered
from 1 to 15. A groove on the edge of the disc allows the exact positioning of the hole to be utilised.
Its number must appear in the flange’s semi-circular seat. The rotation of the disc is obtained by
loosening the butterfly nuts by a few turns. After the operation is done, screw back carefully.
Any faulty sealing condition of the
hydraulic circuit causes an intermit-
tent issuing of the sprayed mate-
rial. It is necessary to carefully che-
ck the efficiency of the sealers and
clamps, the tightening of the ring
nuts and fittings and the good
working condition of the piping.
1
2
2
3
LEGEND
1 - UNION FLANGES
2 - LOCKING NUT
3 - ROTATING DISC WITH CALIBRATED HOLES
00026
E10
Pump
P8
E20
®
+
-
ON
Spin Spin
Remote Control Remote Control
H O
2
H O
2
Press. Press.
Pump
ON
OFF OFF
P19
P20*
P19. ADDITIONAL AGITATION PUMP
(For versions in which this envisaged)
Fastened on the machine right front side, it is connected to the tank (P1) through the pipes (T8 - suction)
and (T11 - delivery).
THE PUMP MUST NEVER RUN DRY : ALWAYS check this point carefully at the start
up and during the functioning.
To avoid any damage to the pump:
- At the first filling and at every next filling after the hydraulic circuit draining, fill the tank with an
appropriate quantity of water to fill the pump
completely.
- The feeding of the 2nd pump is “forced” in any
use condition, even when the sprayer is
working on sloping grounds and/or with the
tank almost empty : in this way the pump does
not run dry.
The pressure sensor (E20) with the low pressu-
re warning light placed on the electrical control
box (E10), or the gauge (P20) can be installed.
00726