Cima BLITZ 45, Инструкция по эксплуатации и обслуживанию, Страница: 53 / 108

4-2012
Blitz 45 - 50 - 55
45
With drawbar for the towk hook the homocinetic joint HAS TO BE MOUNTED ON THE
TRACTOR PTO, with drawbars for the 3-point connection the homocinetic joint HAS TO
BE MOUNTED ON THE SPRAYER PTO. On these conditions, it is possible to carry out
curves having a 70/80° steering angle, with the power takeoff turning.
ANYWAY, THE USER HAS BOTH TO FOLLOW AND TO OBSERVE ALL THE INDICATIONS
SUPPLIED IN THE USE AND MAINTENANCE BOOKLET PROVIDED BY THE HOMOCY-
NETIC CARDAN SHAFT MANUFACTURER.
DEFINITION OF THE TRANSMISSION SHAFT LENGTH
- Follow the same procedures described at Paragraph 5.2.1.
5.3 - INSTALLATION OF REMOTE CONTROLS
5.3.1 - Electrical control panel - E10
1 - Fix the fastening bracket near to the driver (if not already available on the tractor).
2 - Insert the bayonet support of the control panel in the securing clamp and position it so that the
controls are fully visible and accessible during use.
3. Connect the distribution piping (T5) to the hydraulic circuit of the distribution device (head) mounted
on the machine (follow the instructions of the specific “use and maintenance” book-let which is
supplied with it).
4. Connect the feeding pipe (T4) with the electrical distributor (E9).
5 - Connect the power supply cable “W1” plugging it in the socket of the tractor.
ELECTRICAL
CONTROL
PANEL
TO THE
SERVICE
SOCKET
MOUNTING
BRACKET
E10
E9
®
+
-
ON
Remote
Control
H O
2
ON
OFF
OFF
Pump
00085
TO THE ELECTRICAL
DISTRIBUTOR (E9)
W2
W1
00086
ELECTRICAL
DISTRIBUTOR (E9)