Rotary Switch:
1.
Off position.
2.
Work position.
3.
Main/2nd/3rd display setup.
4.
Sockets of K type thermocouples T1 and T2 setup.
5.
RTD (CHA) setup.
6.
ADAPTER (CHB) setup.
7.
Data processing.
8.
Battery test.
9.
Setting.
4. Battery Installation
Remove the two screws from the back of the meter and lift off the battery case.
Note:
It is need to replace the battery less than 20 sec. to avoid the time of system was reset.
6
Press direction keys
or to change the indicator among “READ MEM SAVE”, “READ
MEM LOG” and “READ MEM LIMIT”.
Press “
” key to enter the indicated set of recorded data.
In “READ MEM SAVE” and “READ MEM LIMIT”, press direction keys
or to move
among the data with the measurement reading shown in main display, sequence number in sec-
ond display and time in third display.
There may be more than one group of data in “READ MEM LOG”, right after entering
“READ MEM LOG” data, second show GRP 0001, press direction keys
or to move
among the different group of data, press “
” key to enter the group indicated in second display.
Press direction keys or to move to the data of different channels in the same record and
press direction keys
or to move among the different records of same channel.
Press “ESC” button to leave “VIEW” function and return to “Memory Access Functions Se-
lection mode” with blinking indicator “SET” at upper-right corner.
Press direction keys or to change the blinking indicator to “SET” (SET function) or
“CLR” (Memory Clear function), or to leave this function by turning the Rotary Switch to an-
other position.
SET (SET function : Select the channels for data logging)
When the blinking indicator shows “SET”, press “
” key to enter SET function. The indica-
tor “SET” stops blinking and another small indicator “SET” appears at left side of LCD.
Note: When there is data in the memory, you can not enter “SET” function.
To erase recorded data, please execute “CLR” function mention above.
Right after entering “SET function”, previously selected channel is shown at top of LCD.
Press direction keys
or to change the channel among “T1”, “T2”, “CHA”, “CHB”,
“T1T2”, “CHA T1T2” and “CHB T1T2”.
Press “
” key to confirm selection and return to function selection with indicator “SET”
blinking at upper-right corner of LCD.
Press direction keys
or to change the blinking indicator to “CLR” (Memory Clear
function) or “VIE” (VIEW function), or to leave this function by turning the Rotary Switch to
another position.
Note: When single channel (i.e. T1 or T2 or CHA or CHB) is selected, the selected channel
will be automatically assigned to Main Display and overwrite the previous setting of Main Dis-
play. When multi channel (i.e. “T1 T2” or “CHA T1 T2” or “CHB T1 T2”) is selected the first
channel (i.e. T1 for “T1 T2” or “CHA” for “CHA T1 T2” or CHB for “CHB T1 T2”) will be au-
tomatically assigned to Main Display and overwrite the previous setting of Main Display.
If you do not want this automatic assigned channel shown in Main Display, please re-set the
Main Display (see section 8.1 for setting Main Display). This resetting of Main Display does not
influence the set channel(s) for data logger.
15
Содержание 506A
Страница 1: ...OPERATOR S MANUAL MODEL 506A...
