Christie MicroTiles, Инструкция по установке и настройке

Страница: 18 / 43

Installing the MicroTiles canvas
Perform the following tasks when installing the MicroTiles canvas.
1. Apply the light seal trim (on page 18).
2. Mount leveling feet to the base structure (Optional) (on page 18).
3. Assemble the first row of tiles (on page 19).
4. Add additional rows of tiles (on page 22).
5. Unpack the screens (on page 23).
6. Install the screens on the tiles (on page 23).
7. Connect the cables between the ECUs and tiles (on page 25).
8. Display content on the canvas (on page 27).
9. Power on the MicroTiles array (on page 28).
Applying the light seal trim
The light seal trim is supplied with the Display Unit kit (P/N: 123-001102-xx) and is used to prevent
light leakage between the tiles in the array.
It is typically used for applications where there is lighting in the space behind the tiles.
If required, apply the light seal trim around the back of the outside perimeter of the tile before
adding it to the array.
Mounting the leveling feet to the base structure (Optional)
The leveling feet are used when constructing an array two rows or higher to bolt the array down to
prevent tipping, and to level and tilt small arrays.
Warning! If not avoided, the following could result in death or serious injury.
• TIP HAZARD! Any array two rows or higher, mounted to the leveling feet, must be fastened to an
adequately ballasted base structure to provide stability and prevent tipping.
Installation and Setup
Christie MicroTiles Installation and Setup Guide 18
020-100329-15 Rev. 1 (05-2018)
Copyright
©
2018 Christie Digital Systems USA, Inc. All rights reserved.