1-2
CP2220 Setup Guide
020-100476-05 Rev. 1 (05-2014)
1.3
Power Warnings
To correctly install this cinema projector, a certified electrician must install a permanent a single-phase
connection from the cinema projector to the AC supply. You must operate the cinema projector at the
recommended voltage.
• DO NOT attempt operation if the AC supply is not within the specified voltage range.
• This product does not include a built in AC breaker. A 30-32A double pole, UL listed wall cir-
cuit breaker is required. It must be part of the building installation and easily accessible.
• DO NOT use a wall breaker greater than 32A. This could result in severe damage to the cin-
ema projector in the event of a failure.
• Protection from over-currents, short circuits and earth faults must be part of the building
installation. A disconnect device (double pole switch or circuit breaker with minimum 3 mm
contact gap) must be readily accessible within the projection room.
• Disconnect cinema projector from AC before opening any enclosure.
• DO NOT allow anything to rest on the power cord. Locate the cinema projector where the
cord cannot be damaged by people walking on it or by objects rolling over it. Never oper-
ate the cinema projector if the power cable appears damaged in any way.
• DO NOT overload power outlets and extension cords as this can result in fire or shock haz-
ards.
• Note that only qualified service technicians are permitted to open any enclosure on the
product and only if the AC has been fully disconnected from the product.
1.4
Lamp Precautions
Lamps used in the cinema projector are under high pressure and you must handle them with caution. Lamps
can explode and cause serious personal injury if they are dropped or mishandled.
EXPLOSION HAZARD! Wear authorized protective safety clothing whenever
the lamp door is open!
Recommended protective clothing includes, but may not be limited to a polycarbonate face shield, protective
gloves, and a quilted ballistic nylon jacket or a welder’s jacket. This equipment is included in included in the
Christie Protective Clothing Safety Kit #598900-095.
Lamp may explode causing bodily harm or death. 1) Always wear protective
clothing whenever the lamp door is open or while handling the lamp. 2) Ensure those within
the vicinity of the cinema projector are also equipped with protective clothing. 3) Never
attempt to access the lamp while the lamp is on. Wait a minimum of 10 minutes after the lamp
turns OFF turning the cinema projector off, disconnecting it from a power source, and
opening the lamp door.
The arc lamp operates at a high pressure that increases with temperature. Failure to allow the lamp to
sufficiently cool prior to handling increases the potential for an explosion causing personal injury or property
damage.
WARNING
DANGER
DANGER
Содержание CP2220
