CP2220 Setup Guide
2-13
020-100476-05 Rev. 1 (05-2014)
2.14 Connect the Cinema Projector to AC Power with a Pluggable Type B Con-
nection
When connecting the cinema projector to AC power, follow all electrical codes for your location. In addition,
follow these recommendations:
• There must be easy access to the current protection device or breaker in the building.
• Use 10AWG or 8AWG wiring: the distance between the wall circuit breaker and the cinema projector must
not exceed
20 meters using 10AWG cables or 30 meters using 8AWG cables.
• The socket-outlet is installed near the equipment and is easily accessible.
• The plug can be used as the device disconnect and is near the unit and easily accessible.
1. On the bottom of the cinema projector in the front right corner, loosen the two screws and slide the plate
forward to expose the terminal block.
2. Remove the knockout plate (four screws) located in the bottom right corner of the front bezel.
3. Connect the AC power source to the terminal block, beginning with the ground lead first. Tighten screws
securely.
4. Replace the knockout plate and the bottom access panel over the terminal block.
Figure 2-13
Figure 2-14 Nema-L630A 250V Male Power Plug (
116-102104-01)
Actual Length 1.5 Meters
Содержание CP2220
