Christie CP2220, Руководство по установке

Страница: 24 / 70

2-10 CP2220 Setup Guide
020-100476-05 Rev. 1 (05-2014)
5. With the anamorphic lens not in place, re-focus the primary lens. The goal is good focus at center and on
all sides. Now add the anamorphic lens and check focus again.
6. If center-to-edge horizontal focus in the image needs improvement, rotate the focus barrel.
2.11 Install the Optional Wide Converter Lens
1. Install the Auxiliary Lens Mount and WCL according to the instructions provided with the kit. Ensure the
primary lens is optimized first for best optical alignment, offset and boresight.
2. Adjust the vertical and horizontal position of the WCL to align it with the already adjusted prime lens.
3. Adjust pitch, either up or down to equalize the top and bottom clearance to the prime lens barrel.
4. Adjust yaw so the clearance between both lens barrels is equal from side-to-side.
2.12 Install the Lamp
This procedure should only be performed by a Christie accredited technician.
High-pressure lamp may explode if improperly handled. Always wear approved protective
safety clothing whenever lamp door is open or when handling the lamp.
1. If the cinema projector is operating, turn it off and allow it to cool a minimum of 10 minutes.
2. Turn the breaker switch for the cinema projector off.
3. Disconnect the cinema projector from AC power.
4. Put on your protective clothing and face shield.
5. Use the security key to open the lamp door and access the lamp cooling compartment. Do not place heavy
objects on the open lamp door.
6. Install the anode yoke assembly. Use this table to determine the correct position of the anode yoke
assembly:
Table 2.2 Lamp Types Available for CP2220 and Anode Yoke Position
LAMP TYPE ANODE YOKE POSITION
2.0 kW CDXL-20 Move the lamp cradle as far forward as possible (position
closest to igniter)
3.0 kW CDXL-30
Move the lamp cradle to the rear position, which is approxi-
mately 1” closer to the reflector.
3.0 kW CDXL-30SD (short arc)
3.0 kW CXL-30
DANGER