2 . G e n e r a l D e s c r i p t i o n
CHRISTIE INC. - 35/70 Service/PM Manual
July, 1997
•
brief description of the command
•
key sequence to trigger command
•
RS-232 code for command
•
data input description and format, where applicable
•
resulting projector actions
•
status changes as a result of the command.
When a projector command is referenced, it is written in bold, upper-case typeface. When a value that is stored in a
memory register and tracked by the projector is referenced, it is written in lower case and underlined. Thus,
OUTPUT
STATUS
is a command, and status refers to the status value itself. When a key entry or LED is described, the key's
identity is enclosed in brackets, as <STOP>. If more than one key must be hit, keystrokes are separated by a comma (,).
C 0 : T h e S T O P C o m m a n d [ O P , L ]
This operational command causes the film to stop. The douser automatically closes before the projector stops. The
douser cannot be opened if the film is at a stop.
E
NTRY
:
<STOP>
C
ODE
:
C0
A
CTIONS
:
1. Ramp to a stop if film is in motion.
2. Advance one frame when film is at stop.
3. When operating in a MASTER/SLAVE configuration a C4
<CLOSE DOUSER> command will be sent to the SLAVE
prior to the C0.
S
TATUS
:
Set to 0.
C 1 : T h e F O R W A R D C o m m a n d [ O P , L ]
This operational command causes the projection system to play the current show and then return to the head of
the film. When running the projector in a Master/Slave configuration use the PLAY CURRENT SHOW