3 : O p e r a t i n g t h e P r o j e c t o r
CHRISTIE INC.
CHRISTIE INC. -
-
35/70 Service/PM Manual
July, 1997
E
NTRY
:
<CMD-H>, <5>
C
ODE
:
H5
A
CTION
S
:
1. Display current show in second-from-right position of
numeric display.
2. Display next show in rightmost position of numeric display.
I
NPUT
:
Enter the number of the new current show, using the numeric
portion of the keypad. The number entered cannot exceed the
maximum shows, which is
3
by default but may be set as high
as
6
with the
SET MAXIMUM NUMBER OF SHOWS
command (see Section 0).
A
CTION
S
:
Load the new current show value.
S
TATUS
:
Unchanged.
H 6 : T h e G O T O F R A M E C o m m a n d [ D X , L ]
This diagnostic command triggers the projector to move the film to the point in the show that was previously set with the
SET GOTO
command (see Section 0).
E
NTRY
:
<CMD-H>, <6>
C
ODE
:
H6
A
CTION
S
:
1. Move forward or backward at 120 fps until the goto point
specified with the
SET GOTO
command is reached.
2. Update frame counter.
3. Park.
S
TATUS
:
Set to
8
while searching for goto point.
Set to
0
while stopped at goto point.
H 7 : T h e C U E N E X T C o m m a n d [ O P , L ]
The
CUE NEXT
operational command differs from the
CUE
command (see Section 0) in the way the projector finds the
show that is to be cued.
CUE NEXT
cues the projector in front of the next show in the pre-programmed series of shows
on the film. The
CUE
command cues the projector to the next show located when moving the film in a forward direction.
