Turbo-Cool 6” Recirculating Evaporative Cooling System Manual
15
end).
7. Insert at 2” Mechanical Gripper Plug in the end of the Distribution Pipe. See
Figure 10
.
Figure 10. Distribution Pipe Installation
Sump Assembly Installation
1. Trim the Trough at the Sump end to 5” (12.7 cm) of overhang. Position the
Sump Base at the sump end of the Trough, as shown in
Figure
11
. The Sump
Base should set directly against the end Trough Support.
2. Wipe the inside of the Trough at the sump end to remove debris that may
prevent proper sealing.
Secure the Sump Base in the end of the Trough, using an Adjustable Clamp, as
shown in
Figure 11
.
Item
Description
1
10-16 x 1/2” S.S. Screw
2
5’ Distribution Pipe
3
2” Mechanical Gripper Plug
4
Framing
5
Upper End Panel (R.H)
6
Upper End Panel (L.H.)
7
Lower End Panel (R.H.)
8
Lower End Panel (L.H.)
9
10-1/2” (26.6 cm) Approximately
