Chore-Time LIBERTY Feeding System, Инструкция по установке и эксплуатации, Страница: 29 / 60

LIBERTY® Feeding System with Electronic Sensor (ES) Feeder Line Assembly and Suspension
MF2426B
29
Using the Feed Line actuator, raise the Feed Cone to the E position. The Actuator will stop at the end of the gear.
return the Cones to the A position. Actuator will stop at the end of the gear. Check the position of the Feed Cone.
(Cone should be setting on the stop tabs) See
Figure 52.
Continue to attach the remainder of the feeders to the lift cable, making sure the feeders are in their lowest position
when connected.
Remember to route the cords toward the feed cone actuator.
Anti-Roost Installation
1.Unroll the bulk anti-roost cable. Note: If the cable is unrolled as shown in Figure 54 , taking 5 loops of the
coil with one hand, then changing hands to remove 5 loops as it is unrolled, it will lie flat during installation.
2.Start at the hopper end of the line and form a loop around the anti-roost bracket. For best results, make a
double loop around the anti-roost insulator in the center groove of the insulator and fasten with a 1/16" cable
clamp as shown in
Figure 55.
3.Insert the cable in the insulator on the top of each Grill Support between the hopper and the next anti-roost
bracket.
Figure 53.Actuator at minimum position A
Minimum
Positio "A"
shock2
Figure 54.Unrolling the Cable
Key Description
1 Cable Clamp
2 Clamp with Insulator Bracket
and Insulator
3 Anti-Roost Cable
shock5
Figure 55.Anti-Roost Cable at the Hopper