LIBERTY® Feeding System with Electronic Sensor (ES)
Feeder Line Assembly and Suspension
23
Use a hacksaw or bolt cutters to cut the auger at the stretched auger mark.
15.Insert the Anchor Assembly into the
auger until it touches the washer at the
back of the anchor. Tighten the setscrews
in the center of the anchor until they touch
the auger, then tighten a maximum of 1/2
turn. See
.
Do Not Overtighten Set Screws.
16.Carefully remove the locking pliers while holding onto the Anchor and Bearing Assembly and auger
securely.
17.
Slowly
ease the auger back into the tube. Use caution. If the auger is allowed to spring back, the bearing
race may crack.
18.Install the Bearing Retainer and fasten with a tube clamp. Keep the Bearing Retainer flush with the end of
the anchor for safety.
19.Place the cannonball in the boot.
1523-102 4/2002
Locking Pliers
Use a hacksaw or bolt
cutters to cut the auger
Pull an extra 8"
[200 mm]
of auger (minimum)
to allow for Anchor and Bearing Installation
Boot under Feed Hopper
Figure 39.Cut the Auger with required stretch
KEEP HANDS AWAY FROM
PINCH POINTS WHEN INSTALLING
AUGER.
CAUTION
Roll Pins
Socket head
screw
Auger tip touching
flat washer
anchorbearing1
Figure 40.Anchor Bearing