LIBERTY® Feeding System with Electronic Sensor (ES)
Feeder Line Assembly and Suspension
17
Assemble and Suspend the Feeder Line
1. The auger tubes and feeders may be laid out end to end in approximately the final location of the line.
The belled end of each tube should be toward the Hopper end of the line.
See
.
2. Connect the individual feeder tubes together by inserting the straight end of one tube as far as
possible into the belled end of the next tube.
The last Feeder Tube before the End Control Pan or
Mid Line Control pan needs to be a Control Tube
3. To achieve total feed drop out all
along the system, the Chore-Time
Logo should be centered at the crown
of the tubes and all the Hangers
should be installed as shown in
4. Place a Tube Clamp Assembly or
Clamp/Anti-Roost Bracket at each
joint.
Clamp and Clamp/Anti-Roost
Bracket. Systems using 9’ or 10’
tubes require a Clamp/Anti-Roost
Brackets every fifth joint.
Systems using 12’ tubes require a Clamp/Anti-Roost Bracket at every fourth joint. All other joints in
the system use the standard Tube Clamp Assembly.
Figure 26.Assembling Feeders on the Tubes
Figure 27.Assembling Feeders on the Tubes
1255-86 9/2000
1)
1/4"
[6 mm]
Tube Clamp
1523-86 4/2002
Anti-Roost Bracket
Figure 28.Assembling Feeders on the Tubes