Chore-Time LIBERTY Feeding System, Инструкция по установке и эксплуатации, Страница: 30 / 60

Feeder Line Assembly and Suspension LIBERTY® Feeding System with Electronic Sensor (ES)
30
MF2426B
4.Attach a spring in the center groove at the second anti-roost bracket and cut the cable at this point. See
Figure 56.
5.Thread the ends of the cable through the end of the spring. Pull the cable tight so that there is 3/4" to 1" (20
to 25 mm) of stretch in the spring. Clamp the cable to form a loop and cut off any excess. See Figure 56 .
6.Attach the cable to the insulator . For best results, make a double loop around the anti-roost insulator in the
center groove of the insulator and fasten with a 1/16" cable clamp as shown in Figure 56.
7.Run the cable to the next insulator, attach a spring in the center groove at the anti-roost bracket and cut the
cable at this point. The cable should be positioned in the insulator built into the top of each grill support
along the feeder line.
8.Repeat this installation until the anti-roost cable is installed along the entire feeder line.
9.At the control unit, after clamping the cable to the spring, cut the cable about 8" to 10" (200 to 250 mm)
longer than necessary. Feed the end of the cable through the center of the spring, around the first insulator on
the control unit, and clamp the cable using the cable clamp supplied with the control unit. See
Figure 57 .
10.Install the wire form on the control unit insulators. Be sure the guard snaps into the retainers molded into the
insulators. See Figure 57. At the control unit, after clamping the cable to the spring, cut the cable about 8" to
10" (200 to 250 mm) longer than necessary. Feed the end of the cable through the center of the spring, around
the first insulator on the control unit, and clamp the cable using the cable clamp supplied with the control
unit. See
Figure 57.
11. Anti-Roost Installation at the Control Unit
Key Description
1 Cable Clamp
2 Clamp with Insulator Bracket and Insulator
3 Anti-Roost Cable
4 Spring should be stretched to 3/4” to 1” (19 to 25 mm).
shock
Figure 56.Anti-Roost Cable Mid-Line Connection
Figure 57.Cable hook up at Power Unit.
Clamp
Clamp with Anti-Roost Bracket and Insulator
Insulator
Spring should be stretched
Wire Form
3/4” to 1” [19 - 25 mm]
523-110b 2/2014