Chopin Mixolab, Руководство по обслуживанию

Страница: 108 / 144

108 Chapter 3 Repair
Maintenance manual
MM-MIXO-EN Ind. 0
04/2012
Mixolab
Note: In order to adjust the solenoid valve flow rate, the Mixolab
must be connected to a water valve and to a drained sink
(see sketch opposite).
1. Once the solenoid valve switched off, place the outlet hose in a
graduated vessel (
A ).
2. Reset a chronometer to zero and get ready to start it.
3. Click on solenoid valve icon ( B ) and start at the same time the
chronometer.
4. After 1 minute stop the solenoid valve and the chronometer.
5. Measure the quantity of water in the vessel.
6. If the amount of water is above or below the interval 0.5litre
↔
1litre, the flow rate should be adjusted with the screw located
on the flow limiter (
D ).
11 : Adjustments and checks for the Mixolab
Operation 11-7 Adjusting the flow rate of the cooling circuit solenoid valve
Sheet: 1 / 2
Consumables:
Tools:
-
-
IN
OUT
Inlet hose Outlet hose
A
B
C
D
1L
0.75L
0.5L
D
Flow controller