CHIOSSI E CAVAZZUTI Speedy T 2005, Инструкция по эксплуатации

Страница: 15 / 29

15
via Costituzione 50/D 4201 5 Correggio (RE) Italy - Tel. +39 0522 637224 Fax. +39 0522 631 1 80 cc@chiossiecavazzuti.com
OPERATING THE MACHINE
The garment to be folded is spread on the work table with the back up and the neck towards the
stacker. Press the pedal (or key 1 ) and the machine will execute the active folding cycle (from now
on called program) and will then stop. This cycle will be repeated for each garment to be folded.
PROGRAMS
The different work programs are divided into 3 distinct operating modes described below. If the
machine is not equipped with a stacking device, Stacker Mode is disabled.
PACKAGING MODE
When the machine starts, blade 5 lifts to 45°. The stacker is not needed and should be unhooked
and folded over at the bottom.(fig. 5-1 ). A garment is spread on the work table. At cycle start, blade
5 will lower and the garment will be partially under it. As the cycle continues, the garment will be
folded over the blade. At the end of the cycle, the blade will lift again to 45° with the garment folded
around it. The operator or a second operator can then slip the bag on the garment and remove it
from the blade. Special notches have been made in the blade to facilitate grip.
STACKER MODE
The stacker must be installed on the machine and raised to its working position.
The garment is placed on the work table as described above. The selected folding program starts
and, at its end, blade 5 will rotate almost 1 80° and the folded garment on it will be tipped onto the
stacker platform. Stacker level will automatically adjust to garment thickness. As the work cycles
continue, a stack of garments will be made until full travel (200 mm) has been reached. The
machine will stop and the stacker will lift off completely. The display will show the message "Stacker
full". The machine can only be restarted when the stacker has been emptied.
TIPPING MODE
This an extra cycle offered by the machine. It is used particularly on machines without stackers
combined with a bagging machine. In practice, the program works exactly like stacker mode but
tipping will be onto any work table or machine taking the place of the stacker. This is not a standard
program and will have to be created specially.
SELECTING A PROGRAM
The machine has 1 0 standard programs. Follow these steps to select a program:
- press the Stop key (2 Page 1 0)
- press key "0-9 program" (3 Page 1 0)
- press the number key for the program you want (0-9)
- press "Enter" (1 0 Page 1 0)
The Table below describes the 1 0 standard programs. Programs 5 to 8 require the use of the
stacker. In the Figures, the black rectangle represents the blade making the movement.