CHIOSSI E CAVAZZUTI Speedy T 2005, Инструкция по эксплуатации

Страница: 11 / 29

11
via Costituzione 50/D 4201 5 Correggio (RE) Italy - Tel. +39 0522 637224 Fax. +39 0522 631 1 80 cc@chiossiecavazzuti.com
DIMENSIONS AND HANDLING
PACKING AND SHIPPING
Transport must be done by professionally qualified personnel. The machine must be transported in
such a way as to prevent any damage to its parts. Depending on the type of transport vehicle, the
machine must be protected against any type of impact or strain. The machine is delivered on a
pallet and can then be moved with a forklift truck or transpallet. The machine can also be shipped in
a plywood box invoiced at cost.
Shipping dimensionson
a pallet (wheels dismantled) 1 200 x 750 x 880 (h) mm weight 1 08 Kg
normal crate (wheels dismantled) 1 220 x 770 x 900 (h) mm weight 1 30 Kg
low crate (stacker feet and cylinder dismantled) 1 220 x 770 x 630 (h) mm weight 1 25 Kg
Damage to the machine during transport are NOT covered by warranty.
Repair or replacement of such damaged parts will be charged to the customer.
STORING
If the machine is to be inactive for a long time, it must be put into storage with all the precautions
needed for the storage site and the length of time. Store the machine in a covered area.Grease all
non-painted parts. Protect the machine against bumps and strain. Protect the machine against
humidity and very high or very low temperature. Keep corrosive substances well away from the
machine.
SUITABLE WORK SITES
The folding machine must be installed in a sufficiently large area with enough space around it to
allow the operators to move easily about it. The floor must be level and sufficiently strong to hold the
weight of the machine.
PRELIMINARY CHECKS
Before running the machine, a number of checks and tests should be made to eliminate errors or
accidents during commissioning. Check to make sure the machine has not been damaged during
transport. Check to make sure that all the blades are lowered and the stacker platform (if installed) is
in its working position.
THE WORK TABLE MUST BE CLEAR OF EVERYTHING EXCEPT THE GARMENT TO BE FOLDED.
Check if there is compressed air in the supply circuit. Check to make sure the mains voltage is the
same as that shown on the voltage change jumper sticker.