8
Conversion To A Full Size Bed
Figure 10
AB20034_G14
Bed Rail Kit
(purchased separately)
Long Foot Assembly
from Step 2.
Stationary Side Assembly
from Step 1.
C
C
C
C
H
H
The crib can be converted to a Full Size Bed with
the purchase of a Bed Rail and Slat Kit from
Foundations
®
.
Use Allen Head Bolts (C) and Joint Connectors (H)
from existing hardware. Save the Headboard
Assembly (L) and Footboard Assembly (M) (not
shown) for future use.
For further Full Size Bed configuration refer to
instructions with the Bed Rails and Slats.
See Figure 10.
Installing Guard Rail
Figure 9
AB20034_G13A
Q
T
T
B
B
R
A Guard Rail can be purchased from Foundations
®
added security.
Follow the directions supplied with the purchased
Guard Rail.
The Allen Head Bolts (E) and Connector Nuts (I)
which are at the location where the Guard Rail is to
be assembled will not be installed as explained in
the earlier section.
The addition of the Guard Rail Extenders (T)
included with this Crib and four (4) Allen Head Bolts
(B) also included, will be needed to attach the Guard
Rail. Use Joint Connector Nuts included with the
Guard Rail when installing Allen Head Bolts (B) to
the Guard Rail.
See Figure 9.
Please note that Bolts (D) installed during Step 4
of the crib assembly may need to be loosened
2-3 revolutions to allow extra space during this
process. And it may also be necessary to loosen
Bolt (G) which was threaded into Connector Nut (I)
while installing the Spring (N) during Step 6.
Please also note that only the (2) Bolts (G) and
Connector Nuts (I) on the front side of the crib where
the guard rail will be installed will need loosened.
Once the guard rail is completely installed, please
retighten any hardware items which were loosened.
