9
Maintenance, Cleaning and Storage
MAINTENANCE:
Upon completion of the assembly, check to make sure all screws, bolts and connectors are tightened and
secure. Periodically check crib for damaged hardware, loose joints, missing parts or sharp edges before
and after assembly and frequently during use. DO NOT use crib if any parts are missing or broken.
If any parts are missing, broken or you need Assistance DO NOT return crib to your dealer. Call
Foundations
®
at 330.722.5033 and include model identification numbers recorded on page 1. DO NOT
substitute parts.
CLEANING:
Mix a mild solution of gentle dish washing soap and water, apply to surface using a clean cloth lightly
dampened in the solution. Rinse well with clear water using a soft clean cloth, then dry all surfaces with a
soft dry cloth.
DO NOT use abrasive cleaners or any cleaners with harsh chemicals that would con-
tact a child’s skin, scouring pads, steel wool or coarse rags. This crib should be treated the same
as any fine furniture.
STORAGE:
When storing crib use Caution as extreme temperature or humidity changes could be harmful.
Use caution when a vaporizer is in use. Always aim vapor stream away from crib as well as away
from any wood furniture item.
After completing the assembly the user is advised to read and be aware of ALL WARNINGS,
CAUTIONS, CLEANING, STORAGE USE AND MAINTENANCE notices in these directions and
printed on the storage pouch on the crib spring. A printed pouch is attached to the crib spring
for the permanent storage of the assembly directions. Please place the complete set of
assembly directions into the pouch for future referral. We caution the user to Not place excess
hardware in the pouches as it could present danger to the child if retrieved.
CAUTION
•
ANY MATTRESS USED IN THIS CRIB SHALL BE AT
LEAST 27 1/4 BY 51 5/8 IN. WITH A THICKNESS
NOT EXCEEDING 6 IN. IF YOUR CRIB IS
DESIGNED TO CONVERT TO A TODDLER BED,
THE MATTRESS MUST BE AT LEAST 4 IN.
(100 MM ) THICK.
• UPON COMPLETION OF ASSEMBLY BE SURE ALL SCREWS, BOLTS AND FASTENING DEVICES
HAVE BEEN TIGHTENED SECURELY. A FREQUENT CHECK SHOULD BE MADE OF ALL
SCREWS, BOLTS AND FASTENING DEVICES AND TIGHTEN IF NEEDED.
