ENGLISH
40 Code 9828093379 ed 00 05/2020
CONDENSATE MUST BE DISPOSED OF IN CONFORMITY WITH THE LOCAL REGULATIONS IN FORCE.
- Check the oil level on the indicator Ref. 7 Fig. 18.
- If the oil level is under the minimum, top up as described at point
15.3
.
USE OIL OF THE SAME TYPE AS THAT ALREADY IN THE MACHINE; DO NOT MIX DIFFERENT TYPES OF OIL
15.3 CHECK OIL LEVEL AND TOP UP
- Switch off the machine with pushbutton Ref. 1 Fig. 18.
- Press the button switch Rif. 2 Fig. 18 (on the dryer if fitted).
-
Disconnect the power supply by means of the disconnector switch, Ref. 3 (on the screw-compressor) and Ref. 4 (on the
dryer if fitted) Fig. 18
.
-
WAIT A FEW MINUTES FOR THE FOAM IN THE OIL COLLECTOR TO ABATE.
- Check the oil level on the indicator Ref. 7 Fig. 18.
-
If the oil level is below minimum, fill up as follows
USE OIL OF THE SAME TYPE AS THAT ALREADY IN THE MACHINE; DO NOT MIX DIFFERENT TYPES OF OIL.
BEFORE CARRYING OUT ANY OPERATION ON THE MACHINE, ENSURE THAT THE ELECTRIC POWER SUPPLY
HAS BEEN DISCONNECTED.
- Open the front protection Ref. 5 Fig. 18 using the special key.
- Remove the fixed protection device (machine cover) Ref. 9 Fig. 18.
- Slowly unscrew the oil cap Ref. 8 Fig 18, ensuring there is no pressure inside.
- Top up to maximum level Ref. 7 Fig. 18, with oil of the same type in the compressor.
- Close the oil manifold cap Ref. 8 Fig. 18.
-
Close the fixed protection (machine cover) Ref. 9 Fig. 18 device again, using the appropriate safety screws.
- Close the front protection Ref. 5 Fig. 18.
CHECK OIL LEVEL ONLY AFTER UNIT HAS RUN FOR AT LEAST 5 MINUTES.
DO NOT WAIT TOO LONG AFTER UNIT IS STOPPED, AND FOAM IS DISAPPEARED: OIL MAY MIGRATE
OIL LEVEL CHECK
Running unit:
- Foam level is in the center of sight glass.
Machine just stopped:
- When foam disappears, the sight glass must be almost completely filled with oil.
ATTENTION:
- Do not check level if machine is standing for more than 10 minutes.
-
Do not overfill.
