39
P
rogramming
notes
The Skipper LCD and Skipper Senso have the same remote control memorisation
procedure. For this reason, in the following pages, we will refer to a generic “LCD remote
control” without specifying whether it is a Skipper Senso or an LCD.
On Skipper LCD, being a multi-channel remote control, it is necessary to select the device.
STORING OF THE FIRST REMOTE CONTROL
H
ow
to
Proceed
for
tHe
t
ronic
rX / w
ave
rX / s
enso
rX
motors
and
for
tHe
tds g
old
receiver
:
ATTENTION! This programming is only necessary when the motor or receiver is
installed for the first time, that is to say, when the receiver has not yet been connected
to any remote control. Otherwise, see: “Storing of other remote controls”.
- Make sure that the motor or receiver is supplied with energy.
-
Main menu / Programming / Device / Store + STORE
- After storing, use the UP / DOWN / STOP keys to check whether the motor is operating
correctly.
- After checking, press END PROCEDURE.
STORING OF OTHER REMOTE CONTROLS
Consult the following scheme in order to find the procedure that meets your requirements
and then follow the procedure found in the pages below:
*Remote control of the Skipper series (not LCD) or Giro series
LEGEND:
Tn / Cn: already stored remote control / channel (not LCD)
Tx / Cx: remote control / channel to be stored (not LCD)
LCDx: device to be stored on a LCD remote control
LCDn: device already stored on a LCD remote control
To add:
To another device created using:
Function:
Procedure:
Tn/Cn
LCDx
1
LCD
remote control
LCD
remote control
LCD
remote control
(another) LCD
Another Cherubini
remote control*
ADD FROM
Skipper/Giro
LCD remote control
LCD remote control
LCD remote control LCD remote control
A+B; B
ADD FROM
ADD FROM
LCDn
Tx/Cx
2
Another
Cherubini
remote control*
ADD TO
Skipper/Giro
ADD TO
B
(2 sec)
LCDn
LCDx
3
remote control
ADD TO +
ADD FROM
ADD TO
E
NG
L
IS
H
