37
This section will allow you to change both the basic setups of the remote control
(language, day, time) and the values which have been pre-set in the factory.
SETTINGS
ATTENTION! When you replace flat batteries, all the settings and the programming
carried out until the time of replacement will be held in the remote control memory. The
only exception will be the “time and day”, which will have to be set when the remote
control is started.
LANGUAGE, DAY AND TIME SETTING
Language setting:
Main menu / Settings / Language
Move to the required language using the UP/DOWN keys, press SAVE.
Day & Time setting:
Main menu / Settings / Day & Time
Set the required values*, then press SAVE.
DISPLAY ACTIVATION AND SETTING
Press any key for about 1 second to activate the display.
After the last impulse, the display remains on for a number seconds which can be set (pre-
set value: 30 seconds). During the 10 minutes after being switched off, the display can be
reactivated by slightly pressing a key and the last screen can be visualized. After these 10
minutes (prolonged switch-off), it will be necessary to keep any key pressed for a longer
time (about 1 second). Then, the system will start and will show the System Status screen.
Pre-set value change:
Main menu / Settings / Display > Switch-off
Set the required value* (min 10 sec. – max 90 sec.) and then press SAVE.
In the programming phase it is advisable to set a high value (60 to 90 seconds), while a
low value (10-30 seconds) during daily use is sufficient and helps prolong the life of the
batteries.
Adjustment of the display brightness:
Main menu / Settings / Display > Brightness
Set the required value* (min 00 – max 10), then press SAVE.
*Use the UP/DOWN keys to set the required value.
Press SELECT to move from one box to the other inside the same screen.
E
NG
L
IS
H
