36
The factory settings are the following:
Hysteresis: 250
Brightness: 500
Twilight: 20 (min 0 - max = lower hysteresis frame limit)
It is suggested that these values be changed according to the actual levels ascertained by
the sensor inside of the area being controlled.
Setting the “Automatic Disable” time:
In “Automatic” mode it is always possible to manually command the motor. This action
blocks automatic function of the automation for a period of time that may be set by the
user, as follows:
Value set at the factory: 0 (the automation is not blocked after a manual command).
The value is in minutes (range: 0-120, in steps of 10 minutes).
Sensors Test:
In this screen the remote control reacts immediately to the sensor threshold steps. It is
therefore possible to check if the Skipper Senso is properly communicating with the motor
it is connected to. To perform the test, go to the “Sensors Test” item on the display and
directly change the threshold values. The values now set will be the new remote control
sensor thresholds.
B button:
to go from one
screen to another
A-C buttons:
to set the
values desired
LFT button:
returns to the
Programming Screen without
saving
RT button:
saves and returns
to the Programming screen
B button:
to go from one
screen to another
A-C buttons:
to set the
values desired
LFT button:
returns to the
Main Menu Screen without
saving
RT button:
saves and returns
to the Main Menu Screen
E
NG
L
IS
H
Mar 15:22
PROGRAMMING
Hysteresis
h
Sensors enabling
Timetable
8:00
Device
Season opt.
Select
Start Time 08
00
:
End Time
20
00
:
Manual Disab. 000
Enable
Mar 15:22
TIMETABLE
Select
Save
Mar 15:22
MAIN
Select
Save
Mode
Manual
Settings
Programming
Automation
Sensors Test
TEST
Mar 15:22
SENSORS TEST
Save
Regolation
Temperature: 35°C
Brightness:
0500
Mar 15:22
MAIN
Select
Save
Mode
Manual
Settings
Programming
Automation
Sensors Test
TEST
