Charlton & Jenrick Edge 3s BF, Руководство пользователя

Страница: 9 / 40

www.charltonandjenrick.co.uk 9 LT8019
SECTION FOUR Fuel Bed Cleaning and Layout (Users Instructions)
Warning: -
•
Before you clean any part of the appliance ensures that the appliance is turned off and cold.
•
Use only the fuel bed components provided and no additional parts must added.
•
Incorrect positioning of the fuel bed components could result in the staining of the glass panel.
Important: - Refer to the ‘Health & Safety Notice located on page 5 of this booklet before cleaning or replacing any
refractory material.
•
The fuel bed components are delicate and they should be handled with great care.
•
The loose log shapes may be removed for cleaning. They can be brushed very gently with a soft brush to
remove dust or any deposits.
• A vacuum cleaner may only be used after the loose log shapes and vermiculite has been removed.
CARE SHOULD BE TAKEN TO AVOID DAMAGE TO THE LOG SHAPES AS THESE ARE A DELICATE SURFACE AND SHOULD
NOT BE WIPED OR RUBBED.
It is important that all the log fuel bed shapes are positioned as shown in these instructions.
Log fuel bed layout
Place log shape No1 on its locating pin at the centre rear of the burner. Place a thin layer of vermiculite on the
burner taking care around the burner ports. Failure to do so can result in excessive sooting on the appliance.
Locate the front cover plate onto the locating screws ensuring it is tight against the front of the fire.