Charlton & Jenrick Edge 3s BF, Руководство пользователя

Страница: 17 / 40

www.charltonandjenrick.co.uk 17 LT8019
SECTION EIGHT Siting the Appliance (Installation Instructions)
General Requirements
Rear Exit
•
The flue and air duct length must be between 100mm to 600mm. The flue and air duct must not have any bends.
The 600mm length of flue assembly can be cut down as required.
•
The flue outlet must terminate on a suitable outside wall.
•
The minimum flue terminal clearances, which must be maintained are as shown below.
Top Flue Up & Out
•
The flue air duct length must be between 0.5metre & 8metres. The flue air duct will require a 90 degree bend
plus terminal to a maximum length of 8 metre.
•
The outlet must terminate on a suitable outside wall.
•
The minimum flue terminal clearance, which must be maintained are as shown below.
A
Directly below an openable window or other opening. E.g. air brick 300mm
B Below gutters, soil pipes or drain pipes 300mm
C Below eaves 300mm
D Below balconies or carport roofs 600mm
E From vertical drain and soil pipes 75mm
F From internal and external corners 300mm
G Above ground, roof or balcony level 370mm
H From a surface facing the terminal 600mm
I From a terminal facing the terminal 1200mm
J From an opening in a car port into a dwelling e.g. door, window, etc 1200mm
K Vertically from a terminal on the same wall 1500mm
L Horizontally from a terminal on the same wall 300mm
(When installing in a timber framed dwelling reference must be made to the specific installation requirements stated
in
Section 10 Installing the Appliance in Timber Framed Dwelling ).
This appliance can be flued using two methods.