Charlton & Jenrick Edge 3s BF, Руководство пользователя

Страница: 29 / 40

www.charltonandjenrick.co.uk 29 LT8019
SECTION TWELVE Checking Operation of Fire (Installation Instructions)
LAY FUEL BED
Important: -
Refer to the ‘ Health & Safety Notice located on page 5 of this booklet before laying or replacing any refractory
material.
In the event of replacing fuel bed components please use only the specified number of components as illustrated. Only
use fuel bed component provided for this appliance. In the interest of safety and efficiency
of your appliance when
replacing the fuel bed it is essential that the existing fuel bed be removed and the new components are
replaced correctly as a complete set.
Lay Log fuel bed as described under Users Section.
Warning:
It is important that the fuel bed components are positioned as shown in these instructions.
If the fuel bed components are not positioned correctly this may result in damage to the glass.
Once fuel bed is fitted refit the glass
Locate the glass panel within the bottom-retaining bracket and push back against the seals. (Please see Fig 11).
Position the top and side fixing brackets over the edges of the glass panel and slide over the M4 studs.
Refit the nine M4 nuts previously removed and tighten the glass fixings using the nut runner provided with the
appliance.
ADVISE CUSTOMER THAT:
•
The glass front of this fire acts as a dress guard, conforming to BS 1945 (1997) and satisfies the heating
appliance regulations (1991) however; a fireguard conforming to BS6539 (1997) must be used to protect young
children, the elderly, or infirm.
•
The curing effect of heating the coals and other refractory components will cause an initial odour. This is due
to the starch used in the manufacturing process and is non-toxic.
•
Any debris should be cleaned from the appliance. A vacuum cleaner can be used but only after all the loose
log shapes and vermiculite has been removed.
•
The appliance should be serviced annually by a competent person in accordance with these instructions.
•
Demonstrate the lighting and extinguishing procedures to the user. Refer to the user section of this booklet.
Hand these instructions over to the user.