Champion D-H1T, Техническое руководство

Страница: 33 / 74

Figure 15
Float Switch
Troubleshooting Chart
Models D-HBT and D-H1T use a float switch and circuit board to
control tank fill and tank heat.
For Model D-HBT only, the built-in booster heat circuit is also con-
trolled by the float switch.
Operation:
1. When dishwasher main power switch is turned on (wash tank
empty), the drain valve closes allowing cycle time to run for a
minimum of 110 seconds to fill the tank.
2. The float switch ball rises; its normally open contacts close.
The fill circuit times out; the fill solenoid de-energizes, and
the tank heat and booster heat energize.
3. If water level drops below the float level, the float switch ball
moves down; heat
de-energizes. The fill solenoid energizes and the fill cycle runs for a minimum of 110
seconds to refill the tank.
4. If the tank is not full of water at the end of the 110-second fill cycle, then the machine
will cycle again. When the float switch is satisfied, the fill cycle stops after completing
its 110-second cycle.
5. Refer to the float switch troubleshooting chart below (Fig. 15) for a quick guide to eval-
uating float switch problems.
27
BASIC SERVICE
System
Checks
YES
YES
YES
NO
NO
NO
Wash
Tank Fills Constantly
Is Tank Full
of Water?
Is the Float
Ball Up?
Check
Drain
Clean
Float
Assy
Is Heat ON
when called
for?
Replace
Float
Check
Solenoid
Valve
Figure 14
Float Switch