6.0 Operation
18
6.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL
YOU HAVE THOROUGHLY READ AND UNDERSTAND ALL OF THE FOLLOWING
INSTRUCTIONS. CALL YOUR AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY
QUESTIONS.
6.1 Power
– Main Switch
Power is brought to the machine when the main power switch is turned
to the “ON” position (Figure
15). The display and line lights are turned on at this time. The hydraulic motor will not be activated
until a cut cycle is initiated, and it will shut off after the completion of the cut cycle.
Figure 15
–Power On-Off Switches
The display and line lights will shut off after 5 minutes without any activity. This shut-off time can be
changed in the Parameters screen of the Maintenance Mode (section 6.12.2 on page 24). To restore
power to the display and line lights, press any button on the keyboard.
6.2 Start Up
Once power has been turned on, the Titan 230 will show the following display:
When the CLEAR key is pressed the clamp and knife will move up if they are not already in the up
position. Then the backgauge will move to coordinate the true position into the computer. When
55.000
in
Backgauge must move to be preset.
Please clear the table.
Warning! Clamp and Knife may move.
Revision 1.0
Press clear to start
A) Maint
B) Job
