6.0 Operation
19
finished, the machine will be in “Send Mode” and the display will appear similar to the display shown
below:
The backgauge may now be sent to a desired position by simply typing the dimension and pressing
SEND (see the Send Mode section, page 23, for more details).
6.3 Making a Cut
Place the paper against the backgauge and left side guide. Note: If the cut will leave strips of paper
less than 1/2” wide, place the paper against the right side guide. This will prevent the strips from
getting caught in the small opening near the left side guide.
To make a cut, make sure there are no obstructions between the electric eyes, and press both cut
buttons (located beneath the front face of the table) within 1/2 second of each other. Hold the buttons
in until the knife reaches the table. Releasing the cut buttons at any time during the cut cycle will
immediately send the knife and clamp to the “up” position.
6.4 Jogging Aid
Always remove the jogging aid from the table before making a cut.
A jogging aid is included as standard equipment with the Titan 230. This tool allows the operator to
load and align paper without the need to place hands or arms under the knife or clamp.
To use, load the paper against the side and backgauge using the jogging aid (Figure 16 & Figure 17).
Remove the jogging aid from the table and make the cut.
Figure 16
5.000
in
>_
A) Maint
B) Job
