Cetetherm AquaEfficiency EFB112 DD, Инструкция по установке, обслуживанию и эксплуатации

Страница: 66 / 86

Cetetherm AquaEfficiency
Installation, service and operating instruction
64
18.9 Change or add an extra sensor
Please see 8.2 Electrical wiring diagram .
Temperature sensors are real or simulated thanks to micro switches.
The affected sensors are S1-S5, Pt1 & Pt2. If a sensor is not present,
corresponding micro switch must be
ON . If the sensor is present and
wired, put the micro switch to OFF position.
18.9.1 Mandatory sensors
Sensor DIP switch
pos no. Description Connection on I/O terminal
0V U1-U3
S1 3 Secondary outlet sensor (DHW),
NTC20K 2 wires 41 42
S2 4 Secondary inlet sensor (CW/Recycling),
NTC20K 2 wires 43 44
S3 5 Primary outlet sensor, NTC20K 2 wires 45 46
18.9.2 Optional sensors
Sensor DIP switch
pos no Description Connection on I/O terminal
0V U4-U5
S4 6 Primary inlet sensor, NTC20K 2 wires 47 48
S5 7 Outdoor temp sensor, heating application
only or AquaEfficiency combined with an
AlfaPilot unit. NTC20k 2 wires 68 69
Sensor DIP switch
pos no Description Connection on I/O
terminal
0V Pt1-Pt2
Pt1 1 Temperature sensor, Pt1000, 2 wires 34 35
Pt2 2 Temperature sensor, Pt1000, 2 wires 61 62
18.10 Remote control wiring
The AquaEfficiency can be operated by a remote controller. To enable that connect a volt free contact between
BI1 and 0V.
DO NOT power supply this contact!
Volt free contact only.
Wire terminal name Wire terminal number
0V 72
BI1 73
When the contact is open, the unit operates normally. If it is closed, primary and secondary pump are stopped
and valves get a 0% (0 volt) signal AquaEfficiency is in standby but the controller display remains activated.
18.11 Add an actuator
The 0V contact is common for both the 0-10V signal and the 24V AC actuator power supply.
Description Connection on I/O terminal
No Marked
24VAC, 22VA max 38 24VAC
0-10 VDC 39 AO1
0V 40 0V