CETAC ASX-1400, Руководство оператора

Страница: 26 / 89

ASX-1400 Autosampler Operator’s Manual
Introduction
1–4
The following standard components are located on the front of the ASX-
1400 and are shipped with the autosampler. Each item corresponds with
a callout in Figure 1–1.
1) Sample Base. The sample base has 10 rear standard positions and
accommodates up to five sample vial racks. Ribs located on the
bottom of the sample base hold the sample vial racks in place.
2) Sample Vial Racks. Depending upon which version of the ASX-
1400 was purchased the rack configuration can be the following. a)
Hold four sets of the Bel-Art sample vial racks. You can choose from
five different rack sizes (with either 21, 24, 40, 60 or 90 vials per
rack). b) The ASX-1400 also can handle five sets of Gilson 60
position number 29 rack. c) Hold three of the APS-1650 80 position
collection racks.
3) Standards Vials. Ten standards vials are included with the
autosampler. The standards vials, which fit into the standards
positions at the back of the sample tray, are 50-milliliter conical
centrifuge vials with caps.
4) Flowing Rinse Station. The rinse station is located in the middle
of the standards positions at the back of the sample base. It comes
with tubing used to connect the rinse station to the rinse source and
the waste container. The rinse station block includes rinse ports for
both the sample probe and the stirring paddle.
5) Z-Drive Assembly. The Z-Drive assembly includes a Z-Axis motor
assembly as well as the sample probe. The Z-Drive motor assembly
attaches onto the autosampler arm. Some ASX-1400 Autosamplers
are equipped with a stirrer, which is located next to the sample
probe.