Initial Setup
Setting the Initial Configuration
46
Setting the CP 3100’s Internal Clock
The CP 3100 has an internal clock that tracks the current date and time. This clock is turned off when
the CP 3100 is shipped. You must set the clock before you use the CP 3100.
1.
Click
CONFIGURATION
. The Date/Time Settings page appears (see Figure 22 on
Figure 22.
Date/Time Settings Page
2.
Enter the information described in the Date/Time Settings page (see Table 3 on page 47).
Click
Update
. A message confirms that the date and time have been updated.
NOTE: Do not change the date or time when the CP 3100 is reading from or writing to virtual or
physical tape cartridges.
NOTE: The Date/Time Settings page has a
Reset
button you can click to cancel your changes.
If you enter the date and/or time using the wrong format, an error message appears showing
the correct format to use. If this happens, click the Back button in your Browser and enter the
appropriate date or time.
